The Sonarworks SoundID Reference Measurement Microphone designed to be used along with Sonarworks SoundID Reference room correction software to obtain accurate room measurements, ensuring optimal correction and precise monitoring.
The SoundID Reference Measurement Microphone is an omnidirectional measurement microphone with an individual calibration profile. Every microphone has been measured by Sonarworks acousticians against an ANSI-certified measurement microphone. This means perfect accuracy within the audible range and freedom from sample-to-sample irregularities.
If you need the SoundID Reference Software as well, the Sonarworks SoundID Reference Speakers & Headphones Software with Microphone is available as a bundle. If you already own the SoundID Reference Microphone and need just the Sonarworks SoundID Reference Speakers & Headphones Software that is available own its own.
Sonarworks SoundID Reference Measurement Microphone Specifications
- Microphone type: electret-condenser
- Transducer type: MEMS
- Frequency response: 20 Hz to 20 kHz
- Polar pattern: omni-directional
- Output impedance: 300 Ω
- Sensitivity: 14 mV/Pa
- Signal-to-noise ratio: 65 dB (A)
- Dynamic range: 106 dB
- Maximum sound level: 124 dB SPL
- Power requirements: +48V phantom power
- Connector type: 3-pin XLR
- Weight: 64 g
- Microphone clip diameter: 21 mm
Sonarworks SoundID Reference Measurement Microphone Includes
- SoundID Reference Measurement Microphone
- SoundID Reference Microphone Clip
- Individual multi-angle calibration profiles for 0°, 30°, and 90° off-axis measurements, incl. TXT format for third-party use
- Manufacturer Warranty
No review yet, Be first to Write a Review