The Drawmer 1960 Tube Preamp & Compressor is a two channel unit with each channel comprised of a completely natural sounding soft knee vacuum tube compressor and an extremely low noise microphone pre-amplifier with switchable 48 volt phantom power.
The Drawmer 1960 Tube Preamp & Compressor provides the ultimate direct interface between the sound source and the recording medium by combining eight active tube stages and the low noise and reliability of solid state electronics. The Drawmer 1960 Tube Preamp & Compressor also offers an auxiliary instrument pre-amp with EQ and brightness switch, which may be routed through both compressor channels. Suitable for a variety of signal sources, from electric guitars and basses to electronic keyboards, and is designed to be deliberately overdriven to add tonal colouration to an instrument. The powerful combination of the classic valve circuit, offering unsurpassed tonality, and the low noise balanced microphone input with up to 60dB of gain has allowed engineers throughout the world to exploit the full potential of high performance condenser microphones. An example of this would be the direct to digital stereo recording of live classical music without the necessity of a mixing console.
Drawmer 1960 Tube Preamp & Compressor Features
- A versatile instrument pre-amplifier with passive EQ and brightness switch, which may be routed through both compressor channels
- Suitable for a variety of signal sources, from electric guitars and basses to electronic keyboards
- Designed to be deliberately overdriven to add tonal colouration to an instrument
- Two low-noise microphone preamplifiers with provision for phantom powering
- Compressor section provides soft-knee compression, with four dual-stage tubes in the signal path
- Switchable Attack and switchable Release with two programme dependent settings
- Traditional moving coil meters monitor either gain reduction or output signal level
- An output gain control provides up to 20dB of make-up gain
Drawmer 1960 Tube Preamp & Compressor Specifications
- Connectors: Mic/Line Balanced XLR (Pin 2 +), Aux Input 1/4 jack (Unbal)
- Input Impedance:
- Line: 20K Ohm
- Mic: 150 to 600 Ohm
- Aux: 47K Ohm
- Maximum Input Level: +16dB (+20dBu)
- Mic Pre-Amp:
- Noise: -129dB (ref 0dBu, 150 Ohm)
- Dynamic Range: 150dB
- Headroom: +21dB
- Output Impedance: 50 Ohm
- Maximum Output Level: +18dB (+22dBu)
- Frequency Response: < 20Hz to 24KHz, -1dB
- Crosstalk: Better than -80dB @ 10KHz
- Noise: (Compressor Section @ Unity Gain) -88dB @ 22Hz 22KHz
- Distortion:
- Unity Gain: +4dBu
- Input: <0.15% @ 100Hz to 10KHz
- Power Requirements: IEC Connector, 115 or 230V (-15% +10%) @ 50-60Hz, 38 Watts
- Dimensions: (W x H x D) 482mm x 88mm x 250mm
- Weight: 6.6 Kg
Drawmer 1960 Tube Preamp & Compressor Includes
- Drawmer 1960 Tube Preamp & Compressor
- Power Cord
- User Manual
- 1 Year Warranty
No review yet, Be first to Write a Review